Synthetic anchor straps provide a quick and economical solution as an anchor point.

MATS03 is a pass through loop anchor strap. It should be installed by passing the smaller flat loop through the large twisted eye to choke around a sound structural element. Take care that the direction of pull on the anchor does not cause the anchor sling to bend back through 180 degrees. After tightening, make your connection to the small flat loop only.

MADD03 is a pass through anchor strap with two D rings. Place the strap over the anchorage point with both D rings hanging below the anchorage point. Pass the small D ring through the large D ring and pull the strap until it is snug around the anchorage point. After tightening the strap, make your connection to the small D ring only.

MALD03 is a pass through anchor strap with a loop and a small D ring. Place the strap over the anchorage with both ends hanging down. Pass the D ring through the loop and tighten. Connect to the D ring only.

MACD03 is a concrete anchor strap. It should be installed by passing the small loop over the end of a vertical rebar element with a minimum diameter of 15 millimeters that will be embedded in the structure. Connect to the D ring only.